Filter
Top Products
FIGURE 21
STEP 21
¯ Slide the 1/2" DIAU-PIN (55) through thebushing in the WOLFF SLEEVE (2) then force 1/2" PAL NUT (54) over end of 1/2" DIAU-PIN
(55).
¯. Slide the WOLFF SLEEVE (2) over the FRAME SUPPORT (1). (NOTE: Make sure the spring pin barrel is facing as shown in FIGURE
21.)
¯ Securely assemble one 3/8" SPRING PIN ASSEMBLY (71) and one THUMBSCREW (95) to the WOLFF SLEEVE
1/2" LOW
HEIGHT
1/2 X 5-1~/2
’’
FIGURE 22
1/2" LOW
HEIGHT
~)1/2X3
"
STEP 22
¯
Securely fasten the LEG SUPPORT (15) to the BASE (10) using two 1/2 X 3" BOLTS (42), two 1/2" WASHERS (52) and
LOCVAMUTS (49).
¯
Securely attach FRAME SUPPORT (1) to the LEG SUPPORT (15) using one 1/2" X 3" BOLT (42) and one 1/2" LOW HEIGHT LOCKNUT
(50) as shown in FIGURE 22.
¯ Attach two 2 X 16-I/2" PLATES (18) to the FRAME SUPPORT (1) using one 1/2 X 5-1/2" BOLT (47), and one 1/2" LOW
LOCKNUT (50) as shown on FIGURE 22. (NOTE: Securely tighten, then back nut off 1/4 turn to allo~v the 2 X 16-1/2" PLATES (18)
rotate freely.)
16