Filter
Top Products
FIGURE 34
STEP 34
¯ Assemble one 3-1/2" PULLEY (79) around the PEC DEC CABLE (93) and to the PULLEY BRACKET (5) using one 3/8 X
BOLT (36) and one 3/8" LOCKNUT (48) as shown in FIGURE
FIGURE 35
STEP 35
¯ Slide the ends of the PEC DEC CABLE (93) into the bushings on the PEC CAMS (24) as shown on FIGURE
¯ Lay the PEC DEC CABLE (93) over the pulleys and under the cable retaining clips in the CENTER PULLEY BRACKET (21)
shown in FIGURE 35. (NOTE: The bolt holding pulley and cable retaining clips may need to be loosened to align cable
retaining clips with cable.)
24