Filter
Top Products
1/2" LOW HT.
FIGURE 23
STEP 23
¯ Attach WOLFF SLEEVE (2) to the BACK PAD SUPPORT (14) using one 1/2 X 3-1/2" BOLT (43) and one 1/2" LOW lqEIGI~T
LOCKNUT (50). (NOTE: Securely tighten, then back.nut off 1/4 turn to allow the BACK PAD SUPPORT (14) to rotate
freely.) See FIGURE 23.
¯ Attach both 2 X 16-1/2" PLATES (18) to thebushing on the BACK PAD SUPPORT (14) using one 1/2 X 5-1/2" BOLT (47) and one
LOW HEIGHT LOCKNUT (50). (NOTE: Securely tighten, then back nut off 1/4 turn to allow the 2 X 16-1/2" PLATES (18) to rotate
freely.) See FIGURE 23.
¯ Slide one H]NGE TAB (78) on each side of shaft on WOLFF SLEEVE (2). See FIGURE
¯
Stick one 1-1/4" RUBBER BUMPER (85) on the BACK PAD SUPPORT (14) approximately 1/2" from the end of BACK
SUPPORT (14).
¯ At this time, SECURELY tighten the FRAME SUPPORT (1) to the BASE (10) and the FRONT UPRIGHT (11
1/2 I
In [ 1/2 [ 1/2 I 1/2
6
2
I I I I ,,
1
I I I I
I I I
I