Filter
Top Products
FIGURE 18
STEP 18
Loosely assemble two 3-1/2" PULLEYS (79) and two 2-3/8" CABLE RETAINING CLIPS (58) to the CENTER PULLEY
BRACKET (21) using two 3/8 X 2" BOLTS (37), four 3/8" WASHERS (51), and two 3/8" LOCKNUTS (48). See FIGURE
(NOTE: This connection will be tightened after the cable has been routed.)
FIGURE 19
X 4-1/2"
STEP 19
Securely assemble the BEARING HOUSING (17) and the CENTER PULLEY BRACKEY (21) to the FRONT UPRIGHT (11)
shown in FIGURE 19, using two 1/2 X 4-1/2" BOLTS (45), four 1/2" WASHERS (52), and two 1/2" LOCKNUTS (49).
The eonntector plates on the BEARING lqOUSING (17) and the CENTER PULLEY BRACKET (21) have slotted holes. Shift
the BEARING HOUSING (17) down as far as possible and the CENTER PULLEY BRACKET (21) up as far as possible
before tightening.)
¯ Attach two I" X I" GLIDES (87) to plate on the BEARING HOUSING (17) as sho~vn.
14