Filter
Top Products
3/8X3-3/4"
FIGURE 3
STrP 3
¯
Securely attach WEIGHT STACK BASE (3) to BASE (10) using two 1/2 X Y’ BOLTS (42), two 1/2" WASHERS (52),
one 1/2" LOCKNUT (49).
¯ Slide one 3/4 DIA X 11" SHAFT (29) through PRESS ARM LEVER (9) & tube on REAR UPKIGHT (16). See FIGURE
¯ Securely assembe one 3-1/2" PULLEY (79) to PRESS ARM LEVER (9) using one 3/8 X 3-3/4" BOLT (40), two
WASHERS (5I), one 2-3/8" RETAINING CLIP (58), and one 3/8" LOCKNUT (48).
STEP 4
¯
Apply eight 1-3/4 x 3/4" PAKAGLIDES (70) to the INSIDE of RECEIVING
TUBE (13) as shown in FIGURE 4. (NOTE: Throughly clean the inside
surface before attaching PARAGLIDES.)
FIGURE 4