Filter
Top Products
FIGURE 20
STEP 20
Assemble two 314" THRUST WASHERS (68) and two PEC
CAMS (24) to the LEFT (20) & RIGHT (19) PEC ARMS,
shown on FIGURE 20.
¯ Insert four 3/4" FLANGE BEARINGS (69) into the bushings
of the BEARING HOUSING (17).
Insert the LEFT (20) & RIGHT (19) PEC ARMS through
3/4" FLANGE BEARINGS (69) in the BEARING HOUSING
(17) on their respective side as shown, and secure them in place
with two 3/4" STARLOCK COLLARS (73).
Slide two PEC DEC ROLLER PADS (32) onto the LEFT (20)
& RIGHT (19) PEC ARMS until the ROLLER PAD (32)
flush with the bottom of the pec arms.
(NOTE: If a lubricant is required coat the inside of the
ROLLER PAD (32) with rubbing al~:ohol or water. Also,
rotating the pad while pushing up will[ help ease assembly.)
Securely assemble two 3/8" SPRING PIN ASSEMBLIES (71)
to the spring pin barrels of the PEC ARMS (19 & 20).
I
1/2 ] 1/2
6