Filter
Top Products
ENG-64
If a malfunction occurs, check the following before contacting CatEye or your retailer
for repair or service.
Trouble on display
Trouble Check Items Remedy
Display motion becomes
slower.
Is the surrounding tempera-
ture low (below zero degree
Celsius or 32 degrees Fahr-
enheit)?
Temperatures below freezing may result in
slower screen response. Data is not affected.
icon appears.
The remaining battery ca-
pacity for the wristwatch is
low.
Replace it with a new battery (CR2430). After
replacement, be sure to perform the restarting
operation (page 13).
“STOP” appears. The stop reminder function
(page 26) is activated.
Once any sensor signal is received, the stop
reminder is canceled.
Ignore this during measurement.
“MEMORY” icon flashes on
the screen every 2 min-
utes.
The remaining wristwatch
memory capacity is low.
It is recommended to delete the files (page 44).
When using the optional “USB communica-*
tion kit”, delete the files after you send the
saved files to your PC.
“MEMORY FULL” icon
flashes on the screen every
2 minutes.
The data volume exceeded
the wristwatch memory ca-
pacity during measurement.
Measurement data can no longer be recorded.
Delete the files (page 44).
When using the optional “USB communica-*
tion kit”, delete the files after you send the
saved files to your PC.
No displays appear. Is the battery for the wrist-
watch empty?
Replace it with a new battery (CR2430). After
replacement, be sure to perform the
restarting operation (page 13).
Meaningless display ap-
pears.
Perform the restarting operation (page 13).
Cannot measure the cur-
rent speed or cadence
Is the Speed and Cadence
sensor icon on
?
If icon is off, the wristwatch cannot receive
any data. Press the MODE1 or MODE2 button
to cancel the transmission sleep (page 22).
Check whether the distance
between the speed/cadence
sensor and the magnet is too
large.
Adjust the position of the speed/cadence sensor
and that of the magnet correctly. (See “Bicycle
Installation” on page 9.)
Is the sensor zone of the
speed/cadence sensor off
the center of the magnet?
Has the power-saving
mode been activated,
entering Clock mode?
Press the MENU button to switch to Sports mode.
The display may be delayed depending on the
wireless transmission condition. Check wheth-
er any speed signal is received by spinning the
wheel for a while.
For details, see “Automatic recognition of the *
speed sensor ID” on page 6.
Trouble shooting