Filter
Top Products
ENG-53
Setup mode
Continue
3.
Select the sensor ID to be checked.
Select from “HR (heart rate sensor)”, “SP1 (speed sensor 1)”,
and “SP2 (speed sensor 2)” pressing the MODE1 and MODE2
buttons, and then confirm it pressing the SSS button.
HR
↔
SP1
↔
SP2:
MODE2
MODE1
(or)
Confirm :
SSS
SP2* is used when a wristwatch is commonly used for 2
bicycles. Once you synchronize the ID of the second bicycle
equipped with a sensor with SP2 in advance, the wristwatch
can identify the second bicycle automatically.
4.
Press the SSS button to start searching for the ID.
When you select “SP1” or “SP2”, press the RESET button on
the speed sensor. When you selected “HR”, wear the heart
rate sensor (page 12), or transmit a sensor signal according
to the following simple method below.
When the heart rate or speed/cadence is displayed with
“ID-OK” on the screen, synchronization is completed.
Start searching :
SSS
This unit enters the search mode for 5 minutes after starting *
the ID sync. Press the SSS button in the search mode to
cancel the ID synch, and “ID-SKIP” is displayed. If any sen-
sor signal is not received in 5 minutes, “ID-ERROR” is dis-
played. When “ID-SKIP” or “ID-ERROR” is displayed, the ID
has not been synchronized properly.
* Even when the heart rate sensor is not worn,
it transmits a heart rate signal by rubbing both
electrode pads with your thumbs.
Pressing the
5.
MENU button confirms the change, and returns
to the Setup mode “SYNC ID”.
Press the MENU button repeatedly to switch to another mode.
To the mode top/switch the mode :
MENU
When you use * SP2, set the tire circumference of (Sensor 2) according to “Setting
the tire circumference” (page 51).
Electrode pad