CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
TJ Pin
Description
I FC15-7
NEUTRAL SWITCH STATUS
D
FC15-21
SERIAL COMMUNICATION - KEY TRANSPONDER
D
FC15-39
SECURITY ACKNOWLEDGE
I FC15~4.1
STARTER ENGAGE REOUEST
0
FC15-73
STARTER RELAY ACTIVATE
I FC15-80
BATTERY SUPPLY VOLTAGE
D
FC15-92
ENCODED COMMUNICATIONS
ENGINE CONTROL MODULE
‘J Pin
Description
D
EM10-6
OK TO START- ENCODED COMMUNICATIONS
I EMI&15
PARK, NEUTRAL CONFlRMATl0N
D
EM,O-17
SECURITY ACKNOWLEDGE
I EM,,-6
ENGINE CRANK
KEY TRANSPONDER MODULE
v Pin
Description
D
X22-9
SERIAL COMMUNICATION (ENCODED COMMUNICATION)
D
FC22-ll
SERIAL COMMUNICATION - BPM
D
FC**-16
OK TO START iENCODED COMMUNICATION)
D
FC**-17
SECURITY ACKNOWLEDGE (ENCODED COMMUNICATIONI
DUAL LINEAR SWITCH
v Pin
Description
I CC8~2
TCM, DUAL LINEAR SWITCH COMMON GROUND SUPPLY
0
CC%4
NEUTRAL SWITCH STATUS
0
CC8-5
PARK, NEUTRAL CONFIRMATION
Active
GROUND
(Ni
ENCODED COMMUNiCATlON
ENCODED COMMUNICATIONS
GROUND iCRANKlNGi
GROUND (CRANKING,
*+
Active
Inactive
B+ IP. N)
ENCODED COMMUNICATIONS
GROUND iR.D.4.3.21
GROUND ICRANKING) Bt
Active
ENCODED COMMUNICATION
Active
GROUND
GROUND iN)
B+ (P, N,
Inactive
Bt ,P, R, D. 4, 3, 21
B+
Bt
Bc
Inactive
Inactive
GROUND
B7 (P. R, D. 4.3, 21
GROUND CR. D, 4, 3.2)
COMPONENTS
Component
Connector / Type I Color
Location I Access
BA”ERY
BODY PROCESSOR MODULE
DUAL LINEAR SWITCH
BT65, BA”ERY CABLE CLAMP
BTU, BA”ERY CABLE CLAMP
FC15, II-WAY AMP EEEC i GREY
CC8,lZ~WAY MULTILOCK 070, WHITE
TRUNK, BATTERY COVER
BULKHEAD, BEHlND GLOVE BOX
RlGHT HAND SlDE OF GEAR SELECTOR! CENTER CONSOLE
ENGINE CONTROL MODULE
EM,0,28-WAY MULTILOCK 040, GREY
ENGlNE COMPARTMENT, CONTROL MODULE ENCLOSURE
EM,, ,16-WA’,’ MULTILOCK 040, GREY
EM,*/**-WAY MULTILOCK 040, GREY
EM,3,34~WAYM”LTlLOCK040,GREY
EM14, ,*-WAY MULTlLOCK 47, WHlTE
EM15 122.WAY MULTILOCK 47, WHITE
HlGH POWER PROTECTION MODULE
,GNlT,ON SWITCH
KEY TRANSPONDER MODULE
REGULATOR (GENERATOR)
STARTER MOTOR
SUPPRESSION MODULE
BT60, EYELET
BT61, EYELET
BT62, EYELET
BT63, EYELET
FC4,8-WAY MULTlLOCK 070, WHITE
FC**, PO-WAY MULTILOCK 040 i GREEN
P150, S-WAY SUMITOMO 92, BLACK
ST,, EYELET
ST*, EYELET
ST3, EYELET
AN3, SWAY ECONOSEAL 111 LC, RED
RELAYS
Relay
STARTERRELAY
Case Color
BROWN
Connector / Color
EM50, BROWN
ENGINE COMPARTMENT / RH FRONT
TRUNK i ADJACENT TO EATERY
STEERING COLUMN
BELOW lNSTR”MENT PACK
ENGlNE COMPARTMENT, RH FRONT
ENGlNE COMPARTMENT,ENGlNE BLOCK, RH SIDE
ENGlNE COMPARTMENT, RIGHT FRONT
Location / Access
CONTROL MODULE ENCLOSURE RELAYS/ENGINE COMPARTMENT
HARNESS-TO-HARNESS CONNECTORS
Connector
EM*
EM3
EM50
EM63
FC7
PI1
Pi2
ST5
ST6
Type I Color
2O~WAY MULTILOCK 070, GREY
,&-WAY MULTILOCK 070 /WHITE
*-WAY ECONOSEAL 111 HC, GREY
,&WAY MULTliOCK 070 iYELLOW
*O-WAY MULTILOCK 070, WHITE
57.WAY SUMITOMO TS090, BLACK
1%WAY ECONOSEAL 111 LC, BLACK
EYELET
EYELET
Location / Access
PASSENGER ‘A’ POST, LOWER ‘A’ POST FINISHER
PASSENGER ‘N POST, LOWER ‘A’ POST FINISHER
ENGlNE COMPARTMENT, ADJACENT RH TO FALSE BULKHEAD
PASSENGER ‘K POST, LOWER ‘A’ POST FINISHER
ABOVE DIMMER MODULE, COIN TRAY
ENGINE COMPARTMENT, BULKHEAD, REAR OF ENGINE
ENGINE COMPARTMENT, BRACKET ON TOP OF TRANSMiSSlON
ENGlNE COMPARTMENT, RH FALSE BULKHEAD
ENGINE COMPARTMENTiRH FALSE BULKHEAD
GROUNDS
Ground
Location I Type
BT65
EYELET (SINGLE) - BATTERY GROUND STUD
FC17L
EYELET (PAIR, - EMS BULKHEAD GROUND STUD
EMBR
EYELET (PAIR) EMS LH GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
Serial and encoded communications
0 output
B+ Battery voltage
C CAN (Network)
KHz Frequency x 1000
SG Signal Ground
V Voltage (DC)
MS Milliseconds
S
SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTlFlCATlON OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
