CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
V Pin
Description
I FC15-15
IGNITION SWITCHED GROUND
I FC15-32
iGNiTiON SWITCHED GROUND
0
FC15~97
RELAY COlL DRi”E
Active
GROUND
GROVND
Inactive
B-
B+
COMPONENTS
Component
BATTERY
BODY PROCESSOR MODULE
Connector I Type I Color
BT%/ BATTERY CABLE CLAMP
8767, BArrERY CABLE CLAMP
FC15:14-WAY~MPEEEC,GREY
Location / Access
TRUNK, BA”ERY COVER
BULKHEAD, BEHIND GLOVE BOX
FUSE BOX-ENGINE COMPARTMENT
FUSE BOX- ENGINE MANAGEMENT
ENGlNE COMPARTMENTi LH FRONT
ENGINE COMPARTMENT, CONTROL MODULE ENCLOSURE
FVSE BOX- RH HEELBOARD
CA41 i ,&WAY “.T.A FUSE BOX, NATURAL
CA42: 10.WAY “.T A. FUSE BOX I BLACK
913, EYELET
ST, 4, EYELET
RH HEELBOARD / HEELBOARD COVER
FUSE BOX-TRUNK
BT10,1O~WAY “.T.A FVSE BOX, NATURAL
TRUNK ELECTRICAL CARRlER
BTll :,o~WAY “.TA. FUSE BOX, BLACK
BTlZ, ,@WAY” TA FUSE BOX/GREEN
BTlS,,o~WAY U TA FUSE BOX/BLUE
BT64, EYELET
HlGH POWER PROTECTION MODULE
BT60 i EYELET
TRUNK, ADJACENT TO BA”ERY
BT61, EYELET
8162, EYELET
BT63, EYELET
TRANSIT iSOLATlON DE”lCE
BTU, LUCAR - STRAlGHT
ADMCENT TO BATTERY, BATTERY COVER
BTGS, BATTERY CABLE CLAMP
RELAYS
Relay
Case Color
Connector / Color
Location / Access
AUXILIARY POSlTl”E RELAY
BROWN BUS
RH HEELBOARD FUSE BOX/HEELBOARD COVER
IRH HEELBOARD FUSE BOX1
EMS CONTROL RELAY
BROWN
BUS
ENGINE MANAGEMENT FUSE BOX, ENGINE COMPARTMENT
(ENGINE MANAGEMENT FUSE BOW
,GNlTlON POSITIVE RELAY
BROWN BUS
ENGINE COMPARTMENT FUSE BOX, ENGINE COMPARTMENT
(ENGINE COMPARTMENT FUSE BOX,
IGNITION POSITIVE RELAY
BROWN
BUS
LH HEELBOARD FUSE BOXIHEELBOARD COVER
CLH HEELBOARD FUSE BOX)
HARNESS-TO-HARNESS CONNECTORS
Connector
Type / Color
Location / Access
BT4
FC1
SE
ST6
GROUNDS
Ground
54.WAY THROUGH PANEL, BLACK
54.WAY THROUGH PANEL CONNECTOR, BLACK
EYELET
EYELET
Location / Type
BELOWPARCELSHELF,TRUNK,~E~~ B”LKHEAD,RH SIDE
BELOW PASSENGER SIDE AIR VENT/ GLOVE BOX ASSEMBLY
ENGINE COMPARTMENT, RH FALSE BULKHEAD
ENGiNE COMPARTMENT,RH FALSE BULKHEAD
BT65
EYELET (SINGLE) - BA”ERY GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+I
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D Serial and encoded communications B+ Battery voltage KHz Frequency x 1000
0 output
C CAN (Network)
MS Milliseconds
SG Signal Ground
V Voltage (DC)
S
SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted.
“Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
