CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Description
Active
IGNITION SWlTCHED GROUND
IGNITION SWTCHED GROUND
GEYRSHIFT INTERLOCK SOLENOID ACTl”ATE
COLUMN WATCHGEAR KEYLOCK SOLENOlD ACT,“ATE
NOT IN PARK MICROSWITCH STATTUS
BATTERY SUPPLY VOLTAGE
SCP NETWORK
SCP NETWORK
BATTERY SUPPLY VOLTAGE
GROUND
GROUND
B+ iUNLOCKED
B+ (LOCKED,
GROUND IPARK)
B+
* - 1600 HZ
2- 1600 HZ
B+
ENGINE CONTROL MODULE
v Pin
Description
I EM10-10
BRAKE SWITCH
C
EMIO~Z7
CAN NETWORK
C EM,@28
CAN NETWORK
GEAR SELECTOR ILLUMINATION MODULE
V Pin
Description
Active
C
cc14-3
CAN NETWORK
15 - ,500 HZ @ 2.5 v
C CC14A
CAN NETWORK
15 - ,500 HZ @ 2.5 ”
C cc14-8
CAN NErWORK
16-1500Hz@2.6”
C
CCi4-9
CAN NETWORK
16-150clHz@2.6”
INSTRUMENT PACK
77 Pin
Description
Active
S
FC24-19
SCP NETWORK
2 - 1600 HZ
s
FCZ4-20
SCP NETWORK
2 ,600 Hz
C FCZ4~24
CAN NEWORK
15-1500Hz
C
FCZ4-47
CAN NETWORK
1%1500Hz
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
Inactive
B+
BT
GROUND LOCKED,
GROUND (UNLOCKED1
B+ (NOT IN PARK)
B+
B-
Inactive
B-
Inactive
COMPONENTS
Component
BODY PROCESSOR MODULE
BRAKE SWITCH
ENGINE CONTROL MODULE
GEM SELECTOR ILLUMINATION MODULE
GEARSHIFT !NTERLOCK SOLENOID
INSTRUMENT PACK
KEYLOCK SOLENOlD iCOLUMN SWlTCHGEARi
NOT-IN-PARK MICROSWITCH
Connector I Type I Color
FC15,14~W*YAMP EEEC,GREY
CC40,l~WAY MULTlLOCK 070, WHITE
E,,,,O,ZB-WAY M”LTlLOCK040,GREY
EM,, , ,&WAY MULTlLOCK OlOIGREY
EM12,22-WAY MULTiLOCK 040, GREY
EM13,34-WAY MULTILOCK MC, GREY
EMII, 12.WAY MULTILOCK 47, WHITE
EMIS, 22~WAY MULTILOCK 47, WHITE
CC14,10-WAb’ MULTlLOCK 070,WHlTE
CC12;?-WAYM”LTlLOCK070,WHITE
FC24,4WVAYAMPMOD”LE PCBSIGNAL!BLACK
FC25i24-WAYAMP MODULE PCB SIGNAL/BLACK
X5, Z-WAY MULTILOCK 040, BLUE
CC13 / B-WAY MULTILOCK 070, YELLOW
Location
I
Access
BULKHEAD, BEHIND GLOVE BOX
ADJACENT TO THE BRAKE PEDAL MOUNTING ASSEMBLY
ENGlNE COMP*\RTMENT, CONTROL MODULE ENCLOSURE
CENTER CONSOLE ASSEMBLY
GEAR SELECTOR ASSEMBLY/CENTER CONSOLE
FASCIA
COLUMN SWITCHGE*R
CENTER CONSOLE ASSEMBLY
HARNESS-TO-HARNESS CONNECTORS
Connector
CA19
EM1
EM2
FC7
FCI 1
LS3
SC1
Type I Color
P@WAY MULTILOCK 070 /YELLOW
12.WAY *“G*T 1 5, BLACK
Z-WAY MULTILOCK 070, GREY
20.WAY MULTILOCK 070, WHITE
IB-WAY MULTILOCK 070, WHiTE
54.WAYTHROUGH PANEL CONNECTOR, BLACK
12.WA,’ MULTlLOCK 070, WHITE
Location / Access
LH ‘A’ ~0s~ CONNECTOR MOUNTING BRACKET i LOWER ‘x POST FiNisHER
ENGlNE COMPARTMENT,ADJACENTTO ABS PUMP
PASSENGER ‘K POST, LOWER ‘4’ POST FINISHER
ABOVE DIMMER MODULE, COIN TR*Y
ABOVE DIMMER MODULE, COIN TRAY
LH ‘4’ POST, LOWER ‘K POST FINISHER
COLUMN SWlTCHGEAR
Inactive GROUNDS
Ground
Location
I
Type
CUR
EYELET (P/JR) - DRIVE SHAFTTUNNEL GROUND STUD LH SIDE
CCJL
EYELET (PAIR) - RH FRONT BULKHEAD STUD, CABIN SIDE
FC29L
EYELET (PAIR, - LH BULKHEAD GROUND STUD, CABIN SIDE
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
Serial and encoded communications
B+ Battery voltage
KHz Frequency x 1000
0 output
C CAN (Network)
V Voltage (DC)
MS Milliseconds
SG Signal Ground
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted.
“Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF
COMPONENTS
RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
