CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
77 Pin
Description
SRS AUDIBLE BACKUP
IGNITION SWITCHED GROUND
SEAT BELT SWATCH STATUS
IGNITION S’WTCHED GROUND
STARTER ENGAGE REOUEST
BA”ERY SUPPLY VOLTAGE
AUDIBLE WARNiNG SPEAKER
AUDIBLE WARNiNG SPEAKER
SCP NETWORK
SW NETWORK
BATTERY SUPPLYVOLTAGE
Active
ENCODED COMMUNlCATlONS
GROUND
GROUND (UNFASTENED)
GROUND
GROUND (CRANKING)
B-
AUDIO OUTPUT
AUDIO O”TP”T
2- ,600 HZ
2- 1500 HZ
B-
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
Inactive
B+
B+ iFASTENED
B+
B+
Br
COMPONENTS
Component
Connector I Type I Color
Location / Access
AUDIBLE WARNING SPEAKER ,COLUMN SWITCHGEAR
SC? i 1%WAY MULTILOCK 070/WHITE
COLUMN SWITCHGEAR HARNESS,
ADJACENT TO STEERING COLUMN MOTOR
BODY PROCESSOR MODULE
FC15,14-WAY AMP EEEC, GREY
BULKHEAD, BEHIND GLOVE BOX
SEAT BELT SWITCH
SPvWD, Z~WAY MULTILOCK 070, BLACK
DRIVER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector
Type
I
Color
Location I Access
CA23 10.WAY MULTILOCK 070,WHITE
BELOW DRIVER SEAT
FC5
54.WAY THROUGH PANEL CONNECTOR, BLACK
BELOW DRIVER SiDE AIR VENT i COIN TRAY
SC1
12.WAY MULTILOCK 070,WHITE
COLUMN SWITCHGEAR
GROUNDS
Ground
CA25R
CA2SR
Location / Type
EYELET IPAIR) -PASSENGER SEAT GROUND STUD
EYELET IPAIR, - DRIVER SEAT GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
+
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D
Serial and encoded communications
0 output
B+ Battery voltage KHz Frequency x 1000
C CAN (Network)
SG Signal Ground
V Voltage (DC)
MS Milliseconds
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
