CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
v Pin
Description
I FC15.7
NEUTRAL SWITCH STATUS
D
x15-21
SERIAL COMMUNICATION -KEY TRANSPONDER
D
FClS-39
SECURITY ACKNOWLEDGE
I FC15-41
STARTER ENGAGE REQUEST
0 FC15-73
STARTER RELAY ACTIVATE
I FCl5~80
BA”ERY SUPPLY VOLTAGE
D
FC15-92
ENCODED COMMUNiCATlONS
ENGINE CONTROL MODULE
‘J Pin
Description
D
EM10-6
OKTOSTART-ENCODED COMMUNlCATlONS
I EM10-15
PARK, NEUTRAL CONFlRMATlON
D
EM,&77
SECURITY ACKNOWLEDGE
I EM,,-6
ENGINE CRANK
KEY TRANSPONDER MODULE
V Pin
Description
D
FCZZ-9
SERlAL COMMUNlCATiON IENCODED COMMUNICATIONi
D
FCZZ-1,
SERIAL COMM”NlCATlON BPM
D
FCZZ-16
OKTO START (ENCODED COMMUNlCATlONi
D
FC22-17
SECURITY ACKNOWLEDGE (ENCODED COMMUNICATION)
Active
GROUND ,Ni
ENCODED COMMUNICATION
ENCODED COMMUNICATIONS
GROUND ICRANKING)
GROVND ICRANKINGI
B+
Active
B+ (P. N1
ENCODED COMMUNICATIONS
GROUND iCRANKING,
Active
ENCODED COMMUNiCATiON
Inactive
Bt ,P. R, D, 4.3, 21
B+
Bt
B+
Inactive
GROUND
(R.D.4.3.2~
El+
Inactive
COMPONENTS
Component
BATTERY
BODY PROCESSOR MODULE
ENGINE CONTROL MODULE
GENERATOR
HlGH POWER PROTECTION MODULE
IGNITION SWlTCH
KEYTRANSPONDER MODULE
NEUTRAL SWITCH
REGULATOR iGENERATOR
STARTER MOTOR
Connector I Type I Color
Location / Access
BT66, BATTERY CABLE CLAMP
BT67, BA”ERY CABLE CLAMP
FC15,14-WAY AMP EEEC, GREY
EMlO, 28.WAY MULTiLOCK 040, GREY
EM,, ,,6-WAY MULTILOCK 040, GREY
EM12, Z-WAY MULTlLOCK 040, GREY
EM13,34-WAY MULTILOCK 040, GREY
EM14,,2-WAY MULTILOCK 4I:WHITE
EM,S,ZZ-WAY MULTILOCK 47,WHITE
AN1 i EYELET
AN2, EYELET
ST4, EYELET
TRUNK, BA”ERY COVER
BVLKHEAD, BEHIND GLOVE BOX
ENGlNE COMPARTMENT/CONTROL MODULE ENCLOSURE
ENGlNE COMPARTMENT, RH FRONT
BT60 i EYELET
BTS1, EYELET
BT62 1 EYELET
BT63, EYELET
FC4,8-WAY M”LT,LOCK 070 i WHlTE
FC22,20-WAY MULTILOCK 040 i GREEN
CC>,, 3.WAY MULTlLOCK 070, GREY
PISO, SWAY SUMITOMO 92, BLACK
ST,, EYELET
ST2, EYELET
ST31 EYELET
TRUNK, ADJACENT TO BA”ERY
STEERING COLUMN
BELOW INSTRUMENT PACK
GEAR SELECTOR ASSEMBLY, CENTER CONSOLE
ENGINE COMPARTMENT, RH FRONT
ENGINE COMPARTMENT, ENGINE BLOCK i RH SIDE
SUPPRESSION MODULE
RELAYS
Relay
AN3, X-WAY ECONOSEAL 111 LC, RED
Case Color
Connector / Color
ENGiNE COMPARTMENT, RIGHT FRONT
Location / Access
STARTERRELAY
BROWN
EM50, BROWN
CONTROL MODULE ENCLOSURE RELAYS /ENGINE COMPARTMENT
HARNESS-TO-HARNESS CONNECTORS
Connector
EM2
EM3
EM60
FC7
Pi.
PI2
ST5
ST6
Type / Color
IO~WAY MUWLOCK 070, GREY
II-WAY M”LT,LOCK 070, WHITE
2-WAY ECONOSEAL /II HC, GREY
20.WAY MULTILOCK 070, WHITE
57.WAY SUMITOMO TS090, BLACK
IWVAY ECONOSEAL 111 iC, BLACK
EYELET
EYELET
Location / Access
PASSENGER ‘K POST, LOWER ‘K POST FINISHER
PASSENGER ‘iz’ POST, LOWER ‘I’ POST FINISHER
ENGlNE COMPARTMENT, ADJACENT RH TO FALSE BULKHEAD
ABOVE DIMMER MODULE, COlN TRAY
ENGlNE COMPARTMENT, BULKHEAD / REAR OF ENGINE
ENGINE COwARTMENTi BRACKET ON TOP OF TRANSMISSION
ENGlNE COMPARTMENT, RH FALSE BULKHEAD
ENGlNE COMPARTMENT, RH FALSE BULKHEAD
GROUNDS
Ground
Location / Type
BT65
EYELET (SINGLE) - BATTERY GROUND STUD
CCBR
EYELET (PAIR, iii, FRONT BULKHEAD STVD, CABIN SIDE
FC17L
EYELET (PAIR) -EMS BULKHEAD GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE1
4-
The following symbols are used to represent values for Control Module Pin Out data:
I
Input
D Serial and encoded communications
B+ Battery voltage
KHz Frequency x 1000
0 output
C CAN (Network)
V Voltage (DC)
MS Milliseconds
SG Signal Ground
S SCP Network
Hz Frequency
MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding
circuit operation.
THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
ComPonents connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS,
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997
