EPSON Stylus Pro 7000 Revision B
Adjustment Self-Diagnostic Mode Menus 190
ADJ TOP & BOTTOM
This function sets the distances between the P FRONT sensor and heads,
cutter and heads, as well as the P EDGE sensor and heads. You can also use
this function to adjust the top, bottom, and side margins.
1. Make sure "Adj. Top & Bottom" appears, and press the Enter button.
2. The printer prints a check pattern (lines) and cuts off the paper at a fixed
distance.
3. After the printing operation is finished, measure the top, bottom, and
right (HP) side margins using a ruler. Press the item select (Paper Feed) +/
- buttons to enter each of these measurements in 0.1mm increments.
4. After entering the measurements, press the SelecType or Item button
until "Bottom Length xx.xmm" appears, and then press the Enter button.
Figure 5-35. Margin Adjustment Operation
Figure 5-36. Measuring Sections/Margin Adjustment Pattern
Printing Pattern
[SelecType]/[Item]
[Enter]
End
adjustment/
next menu
Top Length 3.0mm
Bottom Length 15.0mm
Side Margin 3.0mm
Feed
direction
Bottom
margin
Top margin
Side
margin
