A SERVICE OF

logo

122
S:\agilent\e8285\REFGUIDE\MANUAL\screens.chp
Chapter 3, Description of Screens
Oscilloscope Screens
Selecting the Oscilloscope’s Input
The oscilloscope’s input is determined by the AF Anl In field setting in the AF
ANALYZER, TX TEST, or DUPLEX TEST screens.
Figure 32 Oscilloscope Input Indicator
Using the Scope To Field
The Scope To field in the AF ANALYZER screen allows you to look at the
signal at different stages in the AF Analyzer’s process. (Refer to the
Scope To
field description, on page 379 to understand the different choices.)
Except for the
Input setting, all the choices are capacitively coupled. If the signal
to be measured is
1 Hz, use the Input setting to provide the needed dc coupling.