Filter
Top Products
Service Manual Functional verification 25
Change the network name
Use this procedure to change the network name assigned to the monitor.
Changing a factory-defined network name
To change the network name:
1. P r e s s to access the Main menu, and then repeatedly press until SERVICE
MENU is highlighted.
2. Press to display the Service menu screen.
3. Press and hold in this order: , , and . The Network Name menu appears.
If the current monitor network name is one of the following factory-defined names:
then the monitor displays the following screen:
4. Verify that YES is highlighted, and press to display the following screen:
Note
This procedure applies only if the current net name is one of the names available
in the Network Name menu. For other network names, see “Changing a custom
network name” on page 26.
Caution Changing the monitor network name will cause the monitor to restart
and seek to connect with the FlexNet network corresponding to the new name.
Do not attempt to change the network name unless you are a qualified
biomedical service engineer or technician.
com.protocol demo.protocol
com1.protocol com2.protocol
com3.protocol com4.protocol
com5.protocol com6.protocol
com7.protocol com8.protocol