Filter
Top Products
9
5. Press two 50mm Square Inner Caps (30) into the
Foot Plate (4).
Lift the Base (1) to align the indicated holes with
the holes in the Foot Plate (4).
Attach the Foot
Plate to the Base with two M10 x 65mm Carriage
Bolts (64) and two M10 Nylon Locknuts (80). Do
not tighten the Locknuts yet.
6. Attach the Seat Frame (8) to the Front Upright (5)
with two M10 x 67mm Bolts (65), two M10
Washers (77), and two M10 Nylon Locknuts (80).
Do not tighten the Locknuts yet.
Attach the Seat Frame (8) to the Front Leg (7)
with two M10 x 70mm Bolts (70) and two M10
Nylon Locknuts (80). Do not tighten the
Locknuts yet.
7. Press a 25mm x 70mm Inner Cap (31) into the
bottom of the Squat Frame (9).
Attach a 90mm Pulley (46) and a Cable Trap (48)
to the Squat Frame (9) with an M10 x 45mm Bolt
(61) and an M10 Nylon Locknut (80). Do not
tighten the Locknut yet; it needs to be loose
until the High Cable (not shown) is assembled
around the Pulley
.
Attach a Squat Frame Roller (53) to the Squat
Frame (9) with an M8 x 85mm Bolt (63) and an
M8 Nylon Locknut (83). Attach the other three
Squat Frame Rollers in the same manner.
1
4
8
65
65
80
77
80
30
30
80
Holes
64
53
53
53
80
70
7
5
46
48
61
63
31
83
80
9
5
7
6