Filter
Top Products
19
41. Attach the Leg Lever Lock (41) to the Front Leg
(7) with an M8 x 69mm Shoulder Bolt (78), an
M10 W
asher (77), and an M8 Nylon Locknut (83).
Make sure that the shoulder of the Bolt is
inserted all the way through the Front Leg.
42. Attach the tether on the Long Pins (57) to the
Butterfly Frame (12) with an M4 x 16mm Self-tap-
ping Screw (82).
Insert the Long Pins (57) into the Butterfly Frame
(12).
41
42
83
41
77
82
57
57
12
78
7
43. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on page 23 of this manual for proper cable routing. If there is any slack in the cables,
you will need to remove the slack by tightening the cables. See TROUBLESHOOTING
AND MAINTE-
NANCE on page 24.