Filter
Top Products
14
20. Note: This step is shown from the other side
of the weight system.
Wrap the Low Cable (55) over a “V”-pulley (47).
Attach the Pulley and a Long Cable
Trap (85) to
the bracket on the Front Upright (5) with an M10
x 60mm Bolt (72) and an M10 Nylon Locknut
(80).
Make sure the Cable Trap is turned to
hold the Cable in the groove of the Pulley.
21. Wrap the Low Cable (55) under a 90mm Pulley
(46). Attach the Pulley and a Cable Trap (48) to
the indicated side of the bracket on the Base (1)
with an M10 x 45mm Bolt (61) and an M10 Nylon
Locknut (80).
Make sure the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
23. Route the Low Cable (55) over the 90mm Pulley
(46) on the Squat Frame (9). Make sure the
Cable Trap (48) is turned to hold the Cable in
the groove of the Pulley. Tighten the M10 Nylon
Locknut (not shown) securing the Pulley to the
Squat Frame.
24.
Wrap the Low Cable (55) under a 90mm Pulley
(46).
Attach the Pulley and a Cable
T
rap (48) to
the bracket on the Base (1) with an M10 x 45mm
Bolt (61) and an M10 Nylon Locknut (80).
Make
sure the Cable T
rap is turned to hold the
Cable in the groove of the Pulley
.
22. Wrap the Low Cable (55) under a 90mm Pulley
(46). Attach the Pulley and a Cable Trap (48) to
the indicated side of the bracket on the Base (1)
with an M10 x 45mm Bolt (61) and an M10 Nylon
Locknut (80). Make sure the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
20
22
21
23
24
80
80
55
5
55
47
85
72
1
55
80
61
46
61
55
46
9
48
48
48
46
46
55
48
80
1
61
62
1