Filter
Top Products
1.
Press three 50mm Square Inner Caps (30) into
the Base (1) and the Stabilizer (2).
Insert two M10 x 68mm Carriage Bolts (60) up
into the Stabilizer (2). Insert four M10 x 65mm
Carriage Bolts (64) up into the Base (1) (see the
inset drawing).
Note: It may be helpful to place
pieces of tape over the heads of the Bolts to
hold them in place.
Slide the Base (1) onto the two M10 x 68mm
Carriage Bolts (60) in the Stabilizer (2).
2. Using the included grease, lubricate an M10 x
77mm Bolt (75). Attach the Squat Base Plate (3)
to the Stabilizer (2) with the Bolt and an M10
Nylon Locknut (80). Do not overtighten the
Locknut; the Squat Base Plate must be able to
pivot easily.
Attach the tether on the Short Pin (56) to the
Stabilizer (2) with an M4 x 16mm Self-tapping
Screw (82). Insert the Pin through the Stabilizer
and the Squat Base Plate (3).
Press two 25mm Round Outer Caps (36) onto the
Rear Upright (6).
Orient the Rear Upright (6) as shown. Slide the
Rear Upright onto the indicated M10 x 68mm
Carriage Bolts (60) and thread two M10 Nylon
Locknuts (80) onto the Bolts. Do not tighten the
Locknuts yet.
1
6
36
Insert Bolt
through
this hole
This angle
is less
than 90
degrees
36
82
56
75
80
60
80
80
2
3
30
30
30
2
64
1
1
2
Before beginning assembly, make sure you
understand the information in the box on
page 6. For help identifying small parts,
see the PART IDENTIFICATION CHART in
the center of this manual.
7
Frame Assembly
60
64