Filter
Top Products
16
30. Identify the High Cable (54). Route the small
ball on the Cable up through the Top Frame (11)
and over a 90mm Pulley (46).
Attach the Pulley
inside the Top Frame with an M10 x 67mm Bolt
(65), two 12.5mm Spacers (59), two M10
Washers (77), and an M10 Nylon Locknut (80).
31. Route the High Cable (54) over a 90mm Pulley
(46) and down through the Top Frame (11).
Attach the Pulley inside the Top Frame with an
M10 x 67mm Bolt (65), two 12.5mm Spacers
(59), two M10 Washers (77), and an M10 Nylon
Locknut (80).
32. Wrap the High Cable (54) under a 90mm Pulley
(46). Attach the Pulley and a Cable Trap (48) to
the Base (1) with an M10 x 48mm Bolt (86), an
M10 Washer (77), and an M10 Nylon Locknut
(80). Make sure the Cable Trap is turned to
hold the Cable in the groove of the Pulley.
33.
Wrap the High Cable (54) over a 90mm Pulley
(46).
Attach the Pulley and a Cable
T
rap (48) to
the second set of holes from the bottom of the
“U”-bracket (39) with an M10 x 48mm Bolt (86)
and an M10 Nylon Locknut (80).
Make sure the
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
30
31
32
80
54
59
59
77
Large
Ball
77
46
65
80
46
1
59
59
77
77
65
54
46
11
77
54
48
80
86
33
48
46
39
54
86
80
11