Filter
Top Products
17
35. Route the High Cable (54) through the Front
Upright (5), the Front Leg (7), and the Leg Lever
(15).
Attach a 90mm Pulley (46) inside the Front Leg
(7), over the High Cable (54), with an M10 x
67mm Bolt (65), two 12.5mm Spacers (59), two
M10 Washers (77), and an M10 Nylon Locknut
(80).
36. Attach a 90mm Pulley (46) inside the Leg Lever
(15), over the High Cable (54), with an M10 x
67mm Bolt (65), two 12.5mm Spacers (59), two
M10 Washers (77), and an M10 Nylon Locknut
(80).
37. Attach a Seat (20) to the Seat Frame (8) with two
M6 x 16mm Screws (67), an M6 x 65mm Screw
(81), and an M6 Washer (74).
34. Wrap the High Cable (54) under a 90mm Pulley
(46). Attach the Pulley and a Cable Trap (48) to
the Base (1) with an M10 x 48mm Bolt (86), an
M10 Washer (77), and an M10 Nylon Locknut
(80).
Make sure the Cable T
rap is turned to
hold the Cable in the groove of the Pulley.
34
35
36
37
15
65
77
77
80
59
59
54
48
80
46
1
54
5
46
15
59
59
77
46
54
65
77
80
7
67
81
74
8
20
77
86
Seat Assembly