Filter
Top Products
18
PROGRAM DESCRIPTIONS
(MAN.) MANUAL
MANUAL PROGRAM: Program “MAN.” is a manual program allowing
the user to have full manual control of the workload. Turn the UP/DOWN
dial to increase or decrease the load.
PRESET PROGRAMS: Program “PROG” is a group of preset automatic
programs, P01 to P12. The proles are shown on the face of the computer.
Turn the UP/DOWN dial to increase or decrease the load level of the
program.
(P04) (P05)
(P07) (P08)
(P06)
(P09)
COMPUTER INSTRUCTIONS
(P01) (P02) (P03)
(P10) (P11) (P12)
USER SETTING PROGRAM: Program “USER” is an automatic program
that allows the user to manually preset each of the 20 intervals. Under
stop mode, use the UP/DOWN dial and ENTER button to edit the program
prole. The program prole will be stored in the memory after setup. You
can modify the prole anytime under the stop mode. NOTE: The changes
can be stored only under stop mode.
When running a program, you still can use the UP/DOWN dial to increase
or decrease the load level of the program. These changes will not be
stored in memory.
(USER) USER SETTING
(PROG) PRESET PROGRAMS
This computer contains 19 different programs. You can preset the program time and the computer will divide
the time into 20 intervals. If you do not set the program time in advance, the computer will use the preset
distance 0.1 mile for each interval to run the program.