Filter
Top Products
ASSEMBLY INSTRUCTIONS
11
STEP 9
There is a “R” decal on the RIGHT PEDAL CAP(78), and a “L” decal on the LEFT PEDAL CAP(79).
Attach the RIGHT PEDAL CAP(78) to the PEDAL ARM(5) on the right side with the LOCKING KNOBS(77),
WASHERS(M10)(63), and CARRIAGE BOLTS(M10x1.5x50mm)(45). Repeat on the left side.
NOTE: You can loosen the LOCKING KNOBS(77) to adjust the PEDAL CAPS(78, 79) to the front or
back. Securely tighten the LOCKING KNOBS(77) after adjustment. Always set the PEDAL CAPS
(78, 79) at the same position on both sides.
STEP 10
Plug the EXTENSION CONTROL WIRE(28) and PULSE CONNECTION WIRES(29) into the COMPUTER(25),
and push the excess wires back into the UPRIGHT(4). Attach the COMPUTER(25) to the plate on the
UPRIGHT(4) with ROUND HEAD SCREWS(M5x0.8x10mm)(94).
NOTE: Be careful not to damage the wires when attaching the COMPUTER(25) to the UPRIGHT(4).
C.
D.
L
R