Filter
Top Products
Our products have been carefully designed to
ensure safe, efficient long term operation.
However, it must be realized that safe use of this
equipment requires that owners carefully read and
follow the Powerline use recommendations, warnings,
and maintenance guidelines in this Owners Manual.
Routine inspection and maintenance is of critical
importance to ensure the maximum safety and
performance of the P1 gym. Powerline uses the
highest quality materials available, but wear is
inevitable. Therefore, you must carefully inspect your
equipment as outlined in the Maintenance Schedule on
the next page.
Be advised that dangerous conditions can arise even
during a warranty period. A warranty does not negate
the owner’s responsibility to thoroughly, carefully and
daily inspect the machine.
Including maintaining the equipment the
owner’s responsibility is also to:
Be sure to always provide adequate
supervision to all end-users.
Be sure to instruct all end-users of proper
usage.
Be sure all supervisors and personal
trainers who instruct end-users on
equipment use are properly trained and
know the function and importance of every
adjustment and setting. Also, be sure these
trainers provide proper instruction to
end users on the fundamentals of strength
training.
CABLES:
While the machine is not in use. Carefully run your
fingers along the cable to feel for thinning or bulging
areas. Replace cables immediately at the first sign
of damage or wear. Do not use equipment until
damaged cable has been replaced.
Visually inspect the cables for fraying, cracking,
peeling or discoloration.
Check slack in cables and re-adjust cable tension
if needed. See pages 34-35.
Check that the jam nut on the selector rod top
bolt is tight.
UPHOLSTERY:
Wipe down after every workout.
Periodically take the time to use a mild soap or a
mild vinyl upholstery cleaner. Avoid using any
abrasive cleaner not intended for use on vinyl.
Keep sharp or pointed objects out of your pockets
NUTS/BOLTS/FASTENERS:
Periodically inspect all nuts and bolts. Tighten if
needed. If bolts seem to loosen periodically, use
Loctite 242 for a long-term cure.
Go through a re-tightening sequence periodically
to ensure that all hardware is properly tensioned.
GUIDE RODS:
Wipe clean with a dust free rag. Lubricate with a
Silicon or Teflon based lubricant.
ADJUSTMENTS / LOCKING PINS / TIGHTEN
ING KNOBS:
Check all pieces for signs of visible wear or
damage.
Check springs in Snap Links and Pop Pins for
proper tension and alignment.
If the spring sticks or has lost its rigidity, replace it
immediately.
ANTI-SKID SURFACES:
Replace if they appear worn or become slippery.
WARNING INSTRUCTION LABELS:
Inspect and familiarize yourself with all safety
warnings and other user information on decals.
Warning, Safety, & Maintenance
36