Filter
Top Products
30
S T E P
12
Be careful to assemble all components in the sequence they are presented.
NOTE
All Pulleys in this step are 90mm diameter.
Leave all pulley bolts hand tight until Step 13 is completed.
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
MM
Inch
A.
5900 mm
Small Ball End Small Ball End
Function Training Arm Pulley Cable(106)
See Diagram 1. Route Small Ball End of Function Training Arm Pulley Cable(106) through Function
Training Arm Pulley Bracket (AE), where pulley (D1) will be installed. Insert Cable (106) into and
through Function Training Arm (H).
B. See Diagram 2. Install Pulley (D1), under Cable (106) and into Function Training Arm Pulley
Bracket (AE) as shown using:
One 58 (10mm x 50mm hex head bolt)
Two 60 (10mm washer)
One 70 (10mm nylon lock nut)
One 58 (10mm x 50mm hex head bolt)
Two 60 (10mm washer)
One 70 (10mm nylon lock nut)
One 53 (10mm x 45mm hex head bolt)
Two 60 (10mm washer)
One 86 (“L” pulley cable plate)
One 70 (10mm nylon lock nut)
C. See Diagram 2. Install Pulley (D2), over Cable (106) and into Function Training Arm (H) as shown in
Diagram 1 using:
D.
E.
See Diagram 1. Route Cable (106) to the upper bracket of Pulley Brackets Assembled (AC).
See Diagram 2. Install Pulley (D3), over Cable (106) and besides the upper bracket of Pulley Brackets
Assembled (AC) as shown using:
One 55 (10mm x 65mm hex head bolt)
Two 60 (10mm washer)
One 70 (10mm nylon lock nut)
See Diagram 1. Route Cable (106) up and through the Double Pulley Bracket (AF).
Install Pulley (D4) and Pulley (D6) into Double Pulley Bracket (AF) with Pulley (D4) under Cable (106)
as shown using: