Filter
Top Products
10
S T E P
2
Be careful to assemble all components in
the sequence they are presented.
A. Insert Plastic Bushing (93) into the Lower Main Frame (A) as shown.
Insert Front Foot Plate (J) into Plastic Bushing (93) and through Lower Main Frame (A) as shown
and attach using:
Two 52 (10mm x 95mm hex head bolt)
Four 60 (10mm washer)
Two 70 (10mm nylon lock nut)
B. Attach End Cap (80)* to Front Foot Plate (J) as shown.
C. Attach Leg Extension Arm (K) to the Lower Main Frame (A) as shown using:
Two 38 (8mm x 20mm round allen head bolt)
Two 61 (8mm x 24mm washer)
Two 81 (Leg Extension Bushing)
One 45 (12mm x 75mm Shaft)*
Tighten the two Allen Screws (8) in the Lower Main Frame (A).
Attach Rubber Stop (19) and Jam Nut (47) as shown into Lower Main Frame(A).
D.
Attach two End Caps (17)* to the top and bottom of Leg Extension Arm (K) as shown.
E. Attach End Cap (17)* to Lower Main Frame (A) as shown.
*NOTE:These parts might be pre-installed.
G. You can now wrench tighten all bolts and nuts in this step.
Leave all pulley bolts hand tight until the final cable installation in Step 13 is completed.
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
MM
Inch