Filter
Top Products
26
S T E P
10
Be careful to assemble all components in the sequence they are presented.
NOTE:
All Pulleys in this step are 110mm diameter.
Leave all pulley bolts hand tight until Step 13 is completed.
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
MM
Inch
A.
B.
C.
See Diagram 1. Route the Cable (107) through Pulley Bracket (AD).
Route Cable (107) around Pulley (B6) and install Pulley (B6) as shown in Diagram 2 using:
One 53 (10mm x 45mm hex head bolt)
Two 60 (10mm washer)
One 70 (10mm nylon lock nut)
See Diagram 1. Route the Cable (107) up and insert into the openning of Rear Upright (C).
Install Pulley (B5) under Cable (107) into Rear Upright (C) as shown in Diagram 2 using:
One 52 (10mm x 95mm hex head bolt)
Two 14 ( pulley spacer)
One 70 (10mm nylon lock nut)
See Diagram 1. Attach the stamped eye end of Cable (107) to the hook on the top of Double Pulley
Bracket (AF) and secure with Acron Cap Nut (40) as shown in Diagram 2.
2670 mm
Ball Stop End
Stamped Eye End
Low Pulley Cable (107)
One 85 (“L” pulley cable plate )