Filter
Top Products
20
S T E P
7
Be careful to assemble all components in the sequence they are presented.
NOTE:
All Pulleys in this step are 110mm diameter, except where noted in Step 7B.
Leave all pulley bolts hand tight until Step 13 is completed.
A. See Diagram 1. Begin at the high pulley station. Route the metal ball end of the High Pulley Cable (104)
up and through the opening where Pulley (A1) will be installed and then down through the next
opening where Pulley (A2) will be installed.
B. See Diagram 2. Install 90mm diameter Pulley (A1) under Cable (104) and into Upper Main Frame (D) as
shown using:
One 52 (10mm x 95mm hex head bolt)
Two 14 (pulley spacer)
One 70 (10mm nylon lock nut)
C. See Diagram 2. Install Pulley (A2) under Cable (104) and into Upper Main Frame (D) as shown using:
One 52 (10mm x 95mm hex head bolt)
Two 14 (pulley spacer)
One 70 (10mm nylon lock nut)
D. See Diagram 1. Route Cable (104) over the top and around pre-installed Pulley (A3) as shown.
Route Cable (104) around Pulley (A4) and install Pulley (A4) into Upper Main Frame (D) as shown in
diagram 2 using:
One 52 (10mm x 95mm hex head bolt)
Two 14 (pulley spacer)
One 70 (10mm nylon lock nut)
E. See Diagram 1. Route Cable (104) between Pulley (A3) and pre-installed Pulley (A5).
Route Cable (104) over the top and around Pulley (A5) and back through Frame (D).
Route Cable (104) down through the small arm sticking out of the Upper Main Frame (D) and pull
entire length of Cable through.
F. See Diagram 2. Install Pulley (A6) under Cable (104) and into the arm sticking out of the Upper Main
Frame (D) using:
One 54 (10mm x 55mm hex head bolt)
Two 48 (pulley spacer)
One 70 (10mm nylon lock nut)
Cable (104) should be hanging down through the bottom of the small arm sticking out of the
Upper Main Frame (D).
G.
See Diagram 2. Attach Press Arm Pulley Cover (U) to Press Arm Pivot (Q) as shown and tighten.
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
MM
Inch
Ball Stop End
Metal Ball End
High Pulley Cable (104)
4260 mm