Filter
Top Products
16
S T E P
5
Be careful to assemble all components in
the sequence they are presented.
A.
Slide Foam Roller Bar (39) into the opening in Lower Main Frame (A) as shown.
Slide two Plastic Washers (25) and two Foam Rollers (22) onto Foam Roller Bar (39) as shown.
Hold Foam Rollers (22) in place with two Plastic Roller End Caps (24) as shown.
B. Slide Foam Roller Bar (39) into the Seat Pad Frame (L) as shown.
Slide two Plastic Washers (25) and two Foam Rollers (22) onto Foam Roller Bar (39) as shown.
Hold Foam Rollers (22) in place with two Plastic Roller End Caps (24) as shown.
C. Slide Foam Roller Bar (39) into the Leg Extension Arm (K) as shown.
Slide two Plastic Washers (25) and two Foam Rollers (22) onto Foam Roller Bar (39) as shown.
Hold Foam Rollers (22) in place with two Plastic Roller End Caps (24) as shown.
D. You can now go through the main frame unit and double check all bolts and nuts are wrench tight.
Do NOT re-tighten any of the pad bolts.
Leave all pulley bolts hand tight until the final cable installation in Step 13 is completed.
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
MM
Inch