Filter
Top Products
4544
... IF THERE IS 00000 MILES/ KM OR 0000 h IN THE
UPPERMOST ROW OF THE TIME OF DAY DISPLAY?
Press and hold SIGNAL/LIGHT and the uppermost row of the time of day
display will change. You may see 00000 MILES / KM which indicates total
cycling distance, 0000 h which indicates total riding time or the current day
(e.g.05). Press and hold for a few seconds as many times as needed until
you can see the current day in the uppermost row.
... THE SPEED READING IS 00 OR THERE IS NO SPEED
READING IN THE DISPLAY DURING THE RIDE?
1. If the 00 readings appear only occasionally, they may be caused by high
voltage power lines in your surroundings.
2. If the 00 readings come more often, you probably have ridden more than
2500 hours with the speed sensor, and it’s time for battery replacement.
3. If you just have started the measurement,you should wait until the code
search is finished and then start riding the bike to succesfully get the
speed signal.
4. In any case, check the correct positioning of the Polar Speed Sensor.
Also check that the distance between the Polar Speed Sensor and the
bike mounted wrist receiver is between 1'4" - 1'8" / 40-50 cm.
5. Check that the spoke magnet is installed correctly and the distance
between the spoke magnet and the sensor is not more than 0.2"/5 mm.
Adjust the spoke magnet by rotating it around the spoke before putting
the metal cover on the magnet.
... ANOTHER CYCLIST IS CAUSING INTERFERENCE?
To avoid crosstalk from another cyclist with a Polar Speed Sensor, keep the
distance of at least 2'4" / 70 cm between your Polar Protrainer XT receiver
mounted on your Polar Bike Mount and the Polar Speed Sensor of the other
cyclist.
... I AM CAUSING INTERFERENCE TO OTHER CYCLISTS?
You may cause crosstalk to other cycle computers or heart rate monitors.
To avoid this, keep a distance of at least 2'4" / 70 cm between your Polar
Speed Sensor and other person’s cycle computers and a distance of at
least 3 feet / 1 metre between your Polar Coded Transmitter and other
cycle computers.
POLAR GLOSSARY
Indicates coded transmission of heart rate. The inner heart flashes to
the beat of your heart.
In the Time of day display indicates that the alarm is on. In the
Measure mode indicates that the sound signal will alarm if you are
exercising outside your target heart rate zone.
- - When starting the heart rate measurement, these flashing lines
indicate the search for coded transmission.
Indicates that you are setting the Cycling mode functions or you are
exercising in Cycling mode. In the Time of day display it indicates that your
most recent exercise was done in Cycling mode.
ALM: Indicates the alarm in watch settings.
AM/PM: 12 hour mode of time.
Chrono: Displays the total exercising time during the heart rate
measurement.
DATE: Indicates the date in watch settings.
Electrodes: The grooved areas of the transmitter, against the skin. Pick
up the heart’s electrical impulses.
FILE: Indicates the File mode.
FILE End: Indicates the end of the file you are reviewing.
FULL: After taking 48 lap times FULL appears in the display. You can
continue taking the lap times but they won't be recorded into the
Protrainer XT's memory.
Graphic bar: The graphic bar consists of four blocks and indicates
the settings of watch, heart rate or cycling functions. A flashing block
means that the setting of that particular function is possible.
PROXT GBR/E 7.2.2001, 09:0144-45