Filter
Top Products
Polar OwnOptimizer™
General
Successful training requires temporary overloading: longer exercise duration, higher intensity, or higher
total volume. In order to avoid severe overtraining, overloading must always be followed by an adequate
recovery period. With an inadequate recovery period, you may experience a decrease in performance as a
result of high training volumes, instead of improvement. Polar OwnOptimizer is an easy and reliable way to
determine whether your training program is optimally developing your performance. Polar OwnOptimizer is
developed for use by healthy adults.
Polar OwnOptimizer is a modification of a traditional orthostatic overtraining test. It is a perfect tool,
embedded in the cycling computer, for everyone training regularly, at least three times a week, for fitness
improvement or to reach competitive targets. This feature is based on heart rate and heart rate variability
measurements taken during an orthostatic test (standing up from relaxed resting). OwnOptimizer helps you
to optimize your training load during a training program so that you experience an increase in performance
and do not undertrain or overtrain in the long run. Polar OwnOptimizer is based on regular long-term
measurements of five heart rate parameters. Two of these five values are calculated at rest, one while
standing up, and two while standing. Each time you perform the test, the cycling computer saves the heart
rate values and compares them to the previous values registered.
Before the Test
Baseline Tests
When you use OwnOptimizer for the first time, six baseline tests should be conducted over a period of two
weeks to determine your personal baseline value. These baseline measurements should be taken during
two typical basic training weeks, not during heavy training weeks. The baseline measurements should
include tests taken after a training day and after recovery days.
Monitoring OwnOptimizer Values
After the baseline recordings, you should continue to perform the test 2-3 times a week. Test yourself
weekly in the morning following both a recovery day and a heavy training day (or a series of heavy training
days). An optional third test can be performed after a normal training day. OwnOptimizer may not provide
reliable information during detraining or in a very irregular training period. If you take a break from
exercise for 14 days or longer, the baseline tests should be performed again.
Performing the Test
The test should always be taken in standardized/similar conditions in order to get the most reliable results.
It is recommended that you take the test in the morning before breakfast. The following basic
requirements apply:
• Wear the heart rate sensor. For further information, see Wear the Heart Rate Sensor (page 14).
• You should be relaxed and calm.
• You can be seated in a relaxed position or lying in bed. The position should always be the same when you
do the test.
• The test can take place anywhere – at home, in the office, at a health club – as long as the test
environment is peaceful. There should be no disturbing noises (for example, television, radio or telephone)
or other people talking to you.
• Avoid eating, drinking and smoking 2-3 hours prior to the test.
Performing the Test
Select Test > Optimizer > Start > Optimizer Lie Down
ENGLISH
50 Tests