Filter
Top Products
11. USING A NEW ACCESSORY
Using a New Accessory
A new sensor purchased as a separate accessory has to be introduced to the cycling computer. This is
called teaching and takes only a few seconds. Teaching ensures that your cycling computer receives
signals from your sensor only, and enables disturbance-free exercise in a group. If you have purchased the
sensor and the cycling computer as a set, the sensor has already been “taught” to work together with the
cycling computer. You just need to activate the sensor in your cycling computer.
You can teach one Speed, Cadence and Power sensor for each bike setting.
Teaching a New Speed Sensor
Select Settings > Bike > Bike1/2/3 > Speed > On/Off.Teach new sensor? is displayed
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Speed sensors. Then select Yes to
confirm teaching. Start test drive is displayed. Rotate the wheel a few times to activate the sensor. A
flashing red light indicates that the sensor is activated. Completed!! is displayed once the teaching process
is over. The cycling computer is now ready to receive speed and distance data.
• Select No to cancel teaching and the already earlier taught speed sensor is taken into use.
Once the speed sensor is taught to recognize the cycling computer, it will do so even if the sensor has been turned
off. When the speed sensor is turned back on Teach new sensor? is displayed. Select NO. If YES is selected, the
monitor goes into teaching mode.
For a video tutorial, go to http://www.polar.com/en/polar_community/videos.
Teaching a New Cadence Sensor*
Select Settings > Bike > Bike1/2/3 > Cadence > On/Off. Teach new sensor? is displayed
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Cadence sensors. Then select Yes
to confirm teaching. Start test drive is displayed. Rotate the wheel a few times to activate the sensor. A
flashing red light indicates that the sensor is activated. Completed!! is displayed once the teaching process
is over. The cycling computer is now ready to receive cadence data.
• Select No to cancel teaching. The cycling computer will not be able to measure cadence data.
Once the cadence sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the cadence sensor is turned back on next time, Teach new sensor? is displayed. Select NO
and the monitor will go into On/Off mode. Select ON to activate the cadence sensor. If YES is selected, the
monitor goes into teaching mode.
For a video tutorial, go to http://www.polar.com/en/polar_community/videos.
Teaching a New Power Output Sensor*
Select Bike > Bike1/2/3 > Power > On/Off. Teach new sensor? is displayed.
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Power Output sensors. Then select
Yes to confirm teaching. Start test drive is displayed. Rotate the wheel a few times to activate the
sensor. A flashing red light indicates that the sensor is activated. Completed!! is displayed once the
teaching process is over. The cycling computer is now ready to receive power data.
• Select No to cancel teaching. The cycling computer will not be able to measure power data.
Once the power sensor is taught to recognize the cycling computer, it will do so even if the sensor has been turned
off. When the power sensor is turned back on, the Teach new sensor? is displayed. Select NO. The monitor will
go into On/Off mode. The power sensor last taught will be taken into use. If Yes is selected, the cycling computer
goes into teaching mode.
ENGLISH
Using a New Accessory 55