Filter
Top Products
9
Nautilus® TreadClimber® Model TC916 Assembly Manual
GETTING STARTED
GETTING STARTED
Select Your Workout Area
Select the location where you are going to put your
Nautilus
®
TreadClimber
®
exercise machine carefully. The
best place for your TreadClimber
®
machine is on a hard, level
surface. You will need at least two feet (61 cm) on each side
and in front of your TreadClimber
®
machine, and at least four
feet (122 cm) behind it for dismount.
Make sure that the location you choose has a grounded,
3-prong power outlet within reach of the TreadClimber
®
machine power cord, preferably to the front of the machine
where you will be less likely to step on the cord during
dismount.
NOTE: The TreadClimber
®
machine is designed to plug into grounded, non-GFI outlets only. To determine if your
outlet or circuit breaker is GFI, look for a test and reset button on them. If they have the test and reset
button it is a GFI outlet or circuit breaker, and therefore not suitable for plugging the TreadClimber
®
machine into.
Power Plug Receptacle
The Commercial Series TreadClimber
®
TC916 has one power plug receptacle located on the front side of the motor pan (see
Figure 1).
Turning on the Power
The TreadClimber
®
exercise machine can be turned on by moving the power switch located at the front of the machine, to
the ON position (see Figure 1).
Understanding the Display and Controls
The TreadClimber
®
console display is a computerized panel used to operate the TreadClimber
®
exercise machine and see
all workout data and operational status. You should familiarize yourself with the operation of the TreadClimber
®
machine
and location of all keys before beginning use. Detailed descriptions and usage information is available in the TreadClimber
®
Commercial Series, Model TC916, Owner’s Manual.
Figure 1: On/Off Switch & Power Plug