Filter
Top Products
14
Tools Needed:
7/16 Socket
Ratchet
Moving Dolly
Lift Bar
Step 1: Remove TC916 from pallet by performing steps
in section “Removing Machine from Pallet” in
this manual.
Step 2: Tilt to 40 degrees (see Figure 1).
While tilted
place 4-wheel moving dolly under center of
TreadClimber
®
frame (see Figure 2).
Step 3: Carefully, lower the TreadClimber
®
Model TC916
onto 4-wheel moving dolly (see Figure 3).
Step 4:
Once in position in the facility, prepare to
remove unit from 4-wheel dolly by locking
castors.
MOVING INSTRUCTIONS
Moving Unit into Position in Facility
Figure 1
Figure 2
Figure 3
Figure 4
WHEN LOWERING THE TREADCLIMBER
®
UNIT ONTO DOLLY BE SURE THAT THE
CASTORS ARE LOCKED SO THAT IT DOES
NOT MOVE OUT FROM UNDER THE
TREADCLIMBER
®
UNIT.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
NOTE: Perform the following moving procedure to position
your TreadClimber
®
Model TC916 in your facility if
your door ways are greater than 40 inches wide.