Filter
Top Products
18
2.0 REMOVING UPRIGHTS
Tools Needed:
• Phillips head screw driver
• 5/32 Allen wrench
• 3/4 inch wrench or socket
• 1/2 inch drive Ratchet
• 1/2 inch drive Torque wrench
Step 1: Remove for the four Button head screws at-
taching the console to the Upright weldment,
disconnect the cables and remove the console
from the machine.
Step 2: Remove the Rear Step as directed in Section 1:
Removing Rear Step.
Step 3: Disconnect the Base Cable (P/N - 17826) from
the Handrail Cable (P/N - 17824) located in the
lower left hand corner (see Figures 2-1 and 2-2).
Step 4:
Remove rear plastic cover by loosening six (6)
screws (see Figure 2-3 and Figure 2-4).
Step 5:
Remove right and left lower plastic parts by
removing seven (7) screws located on the right
and left upright inside panels (see Figure 2-5 and
Figure 2-6).
Step 6:
Remove the four (4) upright bolts (see Figure 2-7)
Step 7:
Wheel upright structure away to safe location
(wheels are integrated into upright portion of
unit).
NOTE: To replace the upright unit, reverse the
directions. The four handrail screws are
to be torqued to a setting of 75 ft. lbs.
Figure 2-1
Figure 2-2
Figure 2-3
Figure 2-4:
Rear plastic cover off.
Figure 2-5:
Lower plastic parts.
Figure 2-6
Figure 2-7
DETACHING AND MOVING THE UPRIGHT PORTION OF
THIS PRODUCT REQUIRES TWO PEOPLE! YOU MUST
HAVE A MINIMUM OF TWO PEOPLE TO PROPERLY
SUPPORT THE HEAVY UPRIGHT STRUCTURE SO THE
CONSOLE DOES NOT FALL AND CAUSE DAMAGE TO
THE UNIT.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
MOVING INSTRUCTIONS