Filter
Top Products
31
Nautilus® TreadClimber® Model TC916 Assembly Manual
ASSEMBLY INSTRUCTIONS
Figure 3: Connecting Ground Wire Straps
Locate the following for this step:
Parts:
• Assembly from Step 2
• 3 Grounding Straps
Hardware:
• 4 Self-tapping screws - .25 x .50 (P/N 22139)
• 5 Lock Washers (P/N - 41260)
Tools:
• Phillips screw driver
3-1 Remove the 3 Grounding straps, 4 Self-Tapping Screws,
and 5 Lock Washers from the parts bag.
3-2 Attach one end of a grounding strap to the right side
of base frame with one screw and lock washer. (See
Figure 3 - Grounding Strap #1.)
IMPORTANT! PLACE RING TERMINAL OF THE
CABLE BETWEEN THE SCREW AND LOCK WASHER.
3-3 Attach the other end of grounding strap to the cross
bar of the lower Upright weldment with a screw and
lock washer . (See Figure 3 - Grounding Strap #1.)
3-4 Attach one end of second grounding strap to the left
side of base frame with one screw and washer. (See
Figure 3 - Grounding Strap #2.)
3-5 Attach the other end of second grounding strap with
one end of third grounding strap to the cross bar of
the lower Upright weldment with a screw and two
washers. (See Figure 3 - Grounding Strap #2 and #3,
and Figure 3A.)
IMPORTANT! LEAVE OTHER END OF THIRD
GROUNDING STRAP FREE. IT WILL BE INSTALLED
IN STEP 10 OF ASSEMBLY PROCESS.
Step 3: Connecting Ground Wire Straps to Base Assembly
Ground Wire
Strap - #1
Ground Wire
Strap - #2
Ground Wire
Strap - #3
Figure 3A: Connecting Ground Wire Straps #2 & #3
Ground Wire Strap - #2
Ground Wire Strap - #3
Ground Wire
Strap connection
between - #2 & #3.