Filter
Top Products
17
Nautilus® TreadClimber® Model TC916 Assembly Manual
MOVING INSTRUCTIONS
1.0 REMOVING REAR STEP
Tools Needed:
• Phillips head screw driver
• Magnetic 3/8” Nut Driver with long shaft
• Magnetic 3/8” socket
• Ratchet
Step 1: Unplug the unit from the power source and ensure
that all power has been drained from the unit.
Step 2: Remove two (2) middle screws (see Figure 1-1).
Step 3: Slide step cover plate back to remove
(see Figure 1-2).
Step 4: Depending upon the Step Weldment style of the
unit:
4A: Remove the four corner screws and slide the
weldment outward (see Figure 1-3).
- OR -
4B: Remove the two side screws. One screw on
left and right, then slide the weldment outward
(see Figure 1-4).
Removing the step cover plate provides access to the I/O
cables needed for the next step.
Figure 1-1
Figure 1-2
TO AVOID ELECTRICAL SHOCK OR DAMAGE
TO THE UNIT YOU MUST POWER OFF THE
UNIT AND MAKE SURE ALL POWER HAS BEEN
DRAINED FROM THE UNIT AND CAPACITORS BY
ENSURING THERE ARE NO LIGHTED LEDS ON
THE CONSOLE.
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
Figure 1-3
Figure 1-4
Four Screws
Two Screws