Filter
Top Products
28
ASSEMBLY INSTRUCTIONS
Step 4: Dismantling Crate
Tools:
• Hammer
4-1 Carefully dismantle the wooden crate to allow
access to the bottom half of the TreadClimber
®
TC916 frame.
NOTE: The TreadClimber
®
TC916 base frame should
be close to the final location for the fully
assembled machine during this step.
Step 5: Removing from Pallet
Tools:
• 7/16 Socket
• Ratchet
5-1 Remove TC916 from pallet by removing
restraining stabilizer brackets with socket and
ratchet from stabilizer feet (see Figure 1).
5-2 Manually slide TC916 to one side of the pallet
- over hanging approximately 12 to 15 inches off
the side of the pallet (see Figure 2).
5-3 Tilt unit to side and slide edge of frame to ground
(see Figure 3).
5-4 Tilt to 40 degrees and move pallet out of the way,
lowering TC916 to ground.
NOTE: When removing the TreadClimber
®
TC916
from pallet you should be placing the unit in its
final position in the facility.
Figure 1
Figure 2
Figure 3
Remove wooden supports
around base assembly.