Chapter 3 Viewing the BCM50 system LEDs 59
BCM50 Installation and Maintenance Guide
Chapter 3
Viewing the BCM50 system LEDs
This section describes the BCM50 system LEDs.
Refer to the following sections for information on the BCM50 system LEDs:
• “System status LEDs”
• “LAN port LEDs” on page 60
• “ADSL router LEDs (BCM50a only)” on page 62
• “Ethernet router LEDs (BCM50e only)” on page 63
• “Media bay module LEDs (expansion units only)” on page 64
System status LEDs
The two system status LEDs on the BCM50, BCM50a, and BCM50e main units, show the current
state of the BCM50 system.
You can view the system status LEDs on the faceplate and on the top of the main unit (see Figure
20). The bottom LED is the power LED, and the top LED is the status LED. Under normal
operating conditions, both LEDs are solid green.
Figure 20 Location of system status LEDs on a main unit
Power LED
Status LED
