Chapter 14 Using Element Manager to set the basic parameters 141
BCM50 Installation and Maintenance Guide
5 Configure the Add Community String attributes. (see Table 29)
6 Click Ok.
7 Repeat steps 4 to 6 to add more community strings.
To configure the SNMP manager list
Use the SNMP manager list to specify IP addresses that are allowed to connect to the SNMP agent.
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select SNMP from the Administrator Access folder.
3 Select the General tab. It is normally selected by default.
4 Click Add... in the SNMP Manager List area. The Add Manager dialog box opens.
5 Enter the IP address in the Manager IP Address field.
6 Click Ok.
7 Repeat steps 3 to 6 to add another manager IP address.
To create user accounts
1 From the Configuration tab, click the Administrator Access folder to expand it.
2 Select Accounts and Privileges from the Administrator Access folder.
3 Select the View by Accounts tab.
4 Click Add... to add a user account. The Add Account dialog box opens.
5 Configure the Add Account attributes. (see Table 30)
Table 29 Add Community String attributes
Attribute Description
Community String Enter the entry name used as key to uniquely identify an individual community
entry on the SNMP agent.
Type of Access Specify the read and write access for this community. Available options are
Read Only and Read/Write.
Table 30 Add Account attributes (Sheet 1 of 2)
Attribute Description
Description Enter a description for this account.
User ID Enter a descriptive name for the user or the user function.
Password Enter a password for this account.
Telset User ID (numeric) If the user performs administration through the telset interface, enter a number
for the user ID.
Telset Password (numeric) Enter a password for the Telset User ID.
