Chapter 24 Replacing an internal component 199
BCM50 Installation and Maintenance Guide
Figure 76 Hard disk and bracket screws
4 Set the hard disk and bracket in the main unit.
5 Press down lightly on the top of the hard disk to ensure that the hard disk bracket is seated
properly.
6 Connect the power cable to the hard disk. Refer to Figure 73 on page 195 for the location of
the cable.
7 Connect the Serial ATA cable to the hard disk. Refer to the figure Figure 73 on page 195 for
the location of the cable.
8 Ensure the fan cable is routed through the cutouts under the hard disk and bracket. Also make
sure that any slack in the fan cable is secured in the clips on the hard disk bracket (see Figure
77 on page 200).
Caution: Use only the screws that you removed from the hard disk in the
procedure “To remove the hard disk” on page 195. Using other screws may
damage the hard disk.
Note: Do not force the cables.
The connectors on the power cable and the Serial ATA cable have a notch that
prevents the cables from being inserted backwards. If the cables do not insert
properly, check that the notch on the hard disk connector is aligned with the
corresponding notch on the cable.
Insert screws
Insert screws
