A SERVICE OF

logo

Chapter 15 Using the Startup Profile to configure parameters 147
BCM50 Installation and Maintenance Guide
4 Remove the USB storage device from the USB port on the BCM50 or the USB hub.
5 Connect the 25-pair cable to the RJ-21 telephony connector on the BCM50 main unit.
The Startup Profile is now loaded on your BCM50 system.
Next step
After you have loaded the Startup Profile, you can connect the data networking cables. Refer to
“Completing the initial installation (optional)” on page 149 for information about connecting these
cables.
Note: The Startup Profile works only on a BCM50 system that has no keycodes loaded.
After the keycodes are loaded, the Startup Profile does not work. This condition prevents
unintentional overwriting of the parameters of a configured system.
Note: Make sure the bootup sequence is complete before removing the USB
storage device from the BCM50 system.