186 Chapter 23 Replacing an expansion unit
N0027152 01N0027152 01
Removing the MBM
After you have removed the expansion unit, use the following procedure to remove the MBM from
the expansion unit.
To remove the MBM
1 Attach one end of a grounding strap to your wrist and the other end to a grounded metal
surface.
2 Grasp the right edge of the MBM ejector lever with your thumb, index and middle fingers.
Pull outward to partially eject the MBM. Pull further on the lever to eject the MBM from the
expansion unit. Refer to Figure 69.
Figure 69 Remove an MBM
3 Grasp the top and bottom edges of the MBM. Remove the MBM from the expansion unit.
Place the MBM in a flat, clean, and static-free surface.
4 Continue to the next step, “Installing the new expansion unit”.
Inserting the MBM in the new expansion unit
To insert the MBM in the new expansion unit, refer to “Installing a media bay module in an
expansion unit” on page 95.
Proceed to the next step, “Installing the new expansion unit”.
Warning: Protect the hardware components against damage from electrostatic
discharge. Always wear a ground wrist strap before you handle components. Always
place the components in a static-free container.
Grasp the edge of the MBM
ejector lever and pull outward
