Filter
Top Products
Z 7 Tr e a d m i l l O w n e r ' s G u i d e
62
CARE AND MAINTENANCE
Or to indicate an error in speed or incline:
INVALID INCLINE DATA
INVALID SPEED DATA
CALIBRATION ABORTED:
NO SPEED SENSOR
4. Remove and replace Safety Key and exit Calibration Mode
e following Error Codes and Service Codes will follow a double “beep”
and show on the display. Service Codes provide preventative maintenance
reminders. A Service Code will repeat for the next five times you start the
treadmill. A Service Code will clear after any key has been pressed. When
an Error Code occurs, call an authorized service technician.
E1: MINIMUM Not used
E1:RANGE
is error occurs when the incline values on the
display do not match the values stored during calibra
-
tion.
E1:STALL
is error occurs when the incline motor does not
move in response to an incline command.
E1:INCLINE
is error occurs when the incline motor moved
without an incline command.
E2:OVERSPEED
is error occurs when acceleration exceeded design
limits.
E2:CAL
is error occurs when the speed displayed does not
match the stored value from calibration.
E2:RECAL
is error occurs when a data error is detected at start
up. e Control Panel has reset to default values.
E5:SENSOR
is error occurs when no speed sensor data has been
detected at the Control Panel.
Error Codes
CARE AND MAINTENANCE
ERROR AND
SERVICE CODES