Filter
Top Products
1-33
Summary Mode
This mode displays a summary of all the aggregate performance
data recorded by the watch while the Chrono was running. This
mode will not show the data recorded for each lap; refer to the
section for Lap Data mode elsewhere in this manual.
Like the data in Lap Data mode, when the Chrono is started from
reset, all the data in Summary mode are cleared, with the excep-
tion of the Odometer data. This can only be cleared manually as
described in the following section.
1-32
INDIGLO
To Summary/
Hold to
go to Time
of Day
Next data
value
Hold to clear
Odometer
Previous data
value
Mode Operation
VIEWING THE DATA
Press DISPLAY (
ᮡ
) or STOP/RESET (ᮢ) to navigate through the
summary data forward and backward, respectively. Hold the button
to scan quickly through the data; release the button to view the
specific data for that data group.
RESETTING THE ODOMETER
While viewing the Odometer value, press and hold START/SPLIT
to set this value back to 0.
What Data Is Stored?
The following data is available for review in Summary mode. Most
of these data rely on information from either the HRM or Speed +
Distance Sensor, so if you were not using either of these devices
in your workout, most of the displays in Summary mode will show
no interesting data.
NOTE: The data is not updated while it is being displayed.
Average Speed – The average speed while the Chrono was running,
computed by dividing distance traveled by the total Chrono time.
Maximum Speed – The largest velocity value received by the
watch while the Chrono was running.