Filter
Top Products
Page 51
COVERS
There are five covers on the machine: two side covers, a back cover, a bottom
cover, and a top cover. The side covers overlap the top cover. The side covers
must be removed before the top cover and/or the bottom cover can be removed.
All covers are held in place with reusable plastic fasteners (refer to Figure 5
for their location). To remove the fasteners, slide either end of the fastener
removal tool under the edge of the pin head (refer to Figure 6). The pin should not
be removed. Pull the cover away from the frame. Do NOT use the fastener
removal tool or any other sharp tool to pry out the fastener base because you
may damage the covers - use the fastener removal tool to remove the pin.
To reinstall the fastener, insert the base of the fastener through the cover
and into the frame. When the base is in place, push the pin in all the way to
secure the fastener.
Side Covers
1. Remove the 14 fasteners on each side cover.
2. Pull the cover away from the frame.
Top Cover
1. Remove both side covers.
2. Lift the top cover away from the frame.
3. Set the top cover in place. Secure the side covers to complete
reinstallation.
PARTS REMOVAL AND REPLACEMENT
TO REDUCE THE RISK OF INJURY, DO NOT OPERATE THE MACHINE WHILE
THE SIDE COVERS ARE REMOVED. DO NOT ROTATE THE STAIRS WHILE
ANYONE'S HANDS ARE INSIDE THE MACHINE.
!
WARNING