Filter
Top Products
Page 31
MAINTENANCE INSTRUCTIONS
HELPFUL HINTS
Read all maintenance instructions thoroughly before beginning work. In some
cases, an assistant is required to perform the necessary tasks. The safety level
given by the design of this equipment can only be maintained when the equip-
ment is regularly examined for damage and wear. Inoperable components shall
be replaced immediately or the equipment shall be put out of use until it is
repaired. All references to the right or left side and to the front or back are made
as if you were on the machine ready to exercise.
TOOL LIST
The following tools are needed to perform service and maintenance:
• Standard screwdriver • Phillips screwdriver
• Combination wrenches (sizes 7/16 - 3/4") • Adjustable wrench
• Combination pliers • External snap ring pliers
• Shop goggles or other eye protection • Wire stripper/crimper tool
• Allen wrench set (sizes 5/64 - 1/4") • Volt-ohm meter (multimeter)
• Socket set or nut driver set • Locking pliers
(sizes 1/4 - 3/4" in 1/16" increments)
MAINTENANCE RECORDS
For ease of maintenance the 4400/4600 PT/CL console will keep track of hours,
number of workouts, time between last servicing, etc. You can quickly access any
of the custom menus by pressing
[LEVEL: ^], [4], [ENTER]. The console will then
display “MACHINE STATUS”. Scroll through the following options:
[ SELECT ] “ RUN HOURS XXXX”*0
[ SELECT ] “ WORKOUTS XXXX” 1
[ SELECT ] “ DISTANCE XXXX” 2
[ SELECT ] “ CONS 90211- XXX ” 3
[ SELECT ] “ STEPMILL” 4
[ SELECT ] -N/A-
[ SELECT ] “ MAINT HOURS xxxx” 6
*The machine may show a few hours of use due to testing at the
manufacturing facility.