Filter
Top Products
8
3
. Attach a Wheel (97) with the M10 Nut (19), and
the M10 x 50mm Bolt (31) that you removed in
s
tep 1. Do not overtighten the Nut; the Wheel
must turn freely.
Press a Base Cap (87) into the Base (95).
31
19
3
97
95
87
4. Identify the Right Upright (89) and the Right
Upright Spacer (91), which are marked “Right.”
Insert the Upright Wire (88) through the Right
Upright Spacer (91) as shown. Then, set the
Right Upright Spacer on the Base (95).
With the help of a second person, hold the Right
Upright (89) near the Base (95). See the inset
drawing. Tie the wire tie in the Right Upright se-
curely around the end of the Upright Wire (88).
Then, pull the other end of the wire tie until the
Upright Wire is routed through the Right Upright.
4
Wire
Tie
89
88
95
88
89
91
88
Wire
Tie