Filter
Top Products
14
1. Make sure that the power cord is unplugged.
Remove the five M4 x 19mm Screws (35) and
the two M4 x 45mm Screws (2) from the back of
the console assembly.
2. Carefully lift the console assembly off of the
Console Base (103). Locate the Pulse Wire (A)
on the console assembly.
3. Connect the wire on the Receiver (B) to the
Pulse Wire (A).
Peel the paper backing off the pad on the bottom
of the Receiver (B) and off the console pad.
Next, hold the Receiver so that the antenna is
oriented as shown. Press the Receiver onto the
console pad.
Remove the Wire Holder (C). Place the wire on
the Receiver (B) between the two plastic pins
and press the Wire Holder back on.
4. See step 1. Reattach the console assembly.
Make sure that no wires are pinched. Discard
the other wires included with the receiver.
If you purchase the optional chest heart rate monitor (see page 23), follow the steps below to install the
receiver included with the heart rate monitor.
3
Wire
A
B
C
Antenna
103
2
Pad
Console
Assembly
Console
Pad
1
3
5
35
35
35
Console
A
ssembly
Console
Assembly
2
2
A